(7)
Remove each 2 E-rings from the front and
rear transport rollers. Then remove 2 bush-
ings, the pulley and the pin.
[E] Entrance roller
(1)
Take off the stationary tray.
P.4-1 "[A] Stationary tray"
(2)
Take off the Junction box unit.
P.4-13 "[A] Junction box unit"
(3)
Close the buffer unit-1 halfway and leave it.
Then remove 1 screw.
(4)
Remove 3 screws, and then take off the
transport guide.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Front transport roller
Pin
Bushing
Pulley
Buffer unit-1
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 48
Pin
Pulley
Bushing
Rear transport roller
Fig. 4-132
Screw
Fig. 4-133
Transport guide
Fig. 4-134