(4)
Release the latch, and then take off the
transport sensor.
[C] Paddle home position sensor (S3)
(1)
Take off the rear cover.
P.4-6 "[G] Rear cover"
(2)
Disconnect all the connectors of the FIN
board and then release the harness from the
clamp.
(3)
Remove 4 screws from the FIN board
bracket.
(4)
Remove 1 screw, and then disconnect the
connector and take off the sensor bracket.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Transport sensor
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 92
Fig. 4-258
FIN board
bracket
Fig. 4-259
Sensor bracket
Fig. 4-260