Toshiba MJ-1104 Service Manual page 112

Notes:
When replacing the front and rear pull-in
guides, adjust the position with a jig. Install
them based on adjustment area B of the jig
so that the gap between the front and rear
finishing tray covers is more than adjustment
area A and less than C.
6LB10056000 JIG-GID-PDL-2
1. Close the buffer unit 1.
2. Place the jig on the rear finishing tray
cover and fix the one with the rear pull-in
guide by 2 screws at the position of
adjustment area B. Measure the height at
the 2 measuring points where there are
no protrusions of the rear pull-in guide as
shown in the figure.
3. After fixing the screws, check that the
dimension of the gap is more than adjust-
ment area A and less than C.
4. Adjust the front pull-in guide in the same
manner.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Jig
Rear pull-in guide
Jig
Rear finishing tray cover
Rear pull-in guide
Measuring point
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 44
C B A
Adjustment area
Fig. 4-121
Fig. 4-122
Fig. 4-123