Table of Contents
Advertisement
20
en | (Optional) Installing an SD card
6
(Optional) Installing an SD card
Notice!
i
Risk of damage to the bubble
Handle the bubble with care. Do not scratch the inside of the bubble which doesn't have a
hard coating.
Notice!
i
Use full size SD cards for maximum reliability. Bosch doesn't recommend the use of
microSD cards or of microSD to SD adapters.
Notice!
i
Before adding or removing a full size SD card from the camera, disconnect all power
sources (including PoE) from the device.
1.
2.
3.
4.
5.
6.
7.
8.
2023-09-29 | V06 | F.01U.410.315
Disconnect power to the camera while adding or removing an SD card.
Push the compliant beam using a small tool (less than 3 mm) through the hole on the
tilt body. Note: The mentioned tool is not included.
Hold and twist on the space on the camera that releases the latch to hold the bubble to
the housing until the bubble starts to rotate, as in number one in the graphic that
follows.
Turn the bubble clockwise 10 degrees while pressing the tool against the button.
Remove the tool once bubble starts to rotate.
Lift the bubble off the camera.
Insert the card into the slot. Note: Do not force the card into the slot. If the card isn't
going in, it may be backwards.
Using a non-metal tool (not supplied) with a flat edge, push down on the SD card until
it locks into position.
3
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
2
1
1
Bosch Security Systems
Advertisement
Table of Contents
