Table of Contents
Advertisement
64
en | Connection
P107
1.
2.
3.
4.
5.
2023-09-29 | V06 | F.01U.410.315
24 VAC ,
50/60Hz,
Power In
24 VAC,
50/60Hz
power to
the camera
Route the high voltage 120/230 VAC lines and ground wire through the 3/4 in. (20mm)
NPS earth-grounded metal conduit fitting on the left side of the box. The power supply
box with a transformer comes with a barrier (see graphic 10.4) that separates the high
voltage side on the left, from the low voltage 24 VAC side on the right. The high voltage
lines must remain to the left of this barrier.
Note: Use of proper grommets is needed to guarantee IP66.
Cut and trim the high voltage 120/230 VAC power and ground wires with sufficient
slack to reach their connector terminal in the box, but not so long as to be pinched by
or to obstruct closing the cover door.
Attach the supplied 3-pin power plug to the incoming high voltage power wires in the
box. Refer to connector P101 in the table above and to the image below for an
illustration of these connections:
Attach the ground wire to the grounding screw.
Connect three wires to the P107 Power Out connector to route the 24 VAC power
supply to the AUTODOME 7100i non-IR model (NDP-7602-Z40). Refer to connector
P107 in the table above and to the image below for an illustration of these connections.
Earth
Ground
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
24 VAC
24 VAC
Line
Neutral
(3.15A
FUSE)
24VAC to
AUTODOME 7100i
NDP-7602-Z40
camera
Bosch Security Systems
N/A
N/A
Advertisement
Table of Contents
