Installing A Pipe Mount - Bosch AUTODOME 7100i Installation Manual

36 en | Installing a pipe mount
9

Installing a pipe mount

Notice!
Risk of water ingress
If you:
i
- remove a camera from its mount but do not replace it promptly, or
- install the mount but do not install the camera immediately,
then you must remove the PCB from the mount to avoid moisture or water ingress and
potential corrosion.
Notice!
Risk of damage to the camera
When you install the camera, you must attach the camera to the mount and tighten all
i
screws before you apply power (PoE and/or 24 VAC ± 10%/ 36 VDC ± 10%) to the mount
(pendant arm mount or pipe mount).
When you want to disconnect a camera from the mount, you must disconnect all live power
(PoE and/or 24 VAC ±- 10%/ 36 VDC ± 10%) from the mount before you remove the camera
from the mount.
Notice!
i
Risk of permanent damage to the camera
The interface board connects only one way to the camera. Make sure that when you install
it in the mount (arm or pipe mount), you install it the correct way.
2023-09-29 | V06 | F.01U.410.315
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Bosch Security Systems