Installing A Mount Power Supply Box (Wall, Mast (Pole), And Corner Mounts) - Bosch AUTODOME 7100i Installation Manual

AUTODOME 7100i│AUTODOME 7100i IR
–
4.
5.
Warning!
Type and source of hazard
!
For units intended to be installed outdoors: All wiring (power and I/O cabling) connecting
to the units must be routed separately inside different permanently earthed metal conduits
(not supplied).
Bosch Security Systems
For a Mast or a pole installation: The metal straps included with the Mast mount
accommodate a pole with a diameter of 4-15 inch (100-380 mm). You must use a
banding tool (sold separately) for a mast or pole installation. Follow the instructions
provided with the banding tool to mount the Mast Plate to the pole. Contact your
Bosch Sales Representative to order Banding Tool P/N TC9311PM3T.
Secure the Power Supply Box to the Corner Plate or Mast Plate using the four (4) 3/8
x1-3/4-inch bolts and split lock washers (supplied).
Attach 3/4-inch (20-mm) NPS watertight, earth-grounded conduit pipe fittings (not
supplied) to the bottom or back holes of the Power Supply Box through which you will
run the power, video, and control data wires.
Installing a mount power supply box (wall, mast (pole), and corner
mounts) - (for non-IR NDP-7602-Z40 camera models) | en
Installation Manual
2023-09-29 | V06 | F.01U.410.315
23