Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
5
Preparing the bubble
Bubble Handling
The bubble may be packaged with a protective plastic sheet. It is recommended that the
bubble remain stored this way until it is ready to install. Limit handling the bubble, as any
scratches can quickly affect visibility.
After you remove the bubble
4
Notice!
i
Risk of damage to the bubble
Handle the bubble with care. Do not scratch the inside of the bubble which doesn't have a
hard coating.
Notice!
i
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
bubble is disconnected from the housing. Bosch recommends that the bubble be removed
from the housing for no more than five (5) minutes.
Bubble Cleaning
If cleaning the bubble is required, use the following procedures and comply with all the
warnings listed below.
Cleaning the Bubble Interior
The extremely soft interior surface should not be cleaned by rubbing or dusting with a cloth.
Use clean dry compressed air, preferably from a spray can, to remove any dust from the
interior surface.
Warning!
Do not use alcohol-based solutions to clean the bubble. This will cause the surface to cloud
!
and, over time, cause stress aging, which makes the bubble brittle.
Cleaning the Bubble Exterior
The exterior of the bubble is hard-coated for extra protection. If cleaning becomes
necessary, only use cleaning solutions and cloths suitable for cleaning safety glass lenses.
Dry the bubble thoroughly with a dry nonabrasive cloth to prevent water spots. Never scrub
the bubble with any abrasive material or cleaners.
Bosch recommends cleaning the exterior of the bubble with NOVUS "No. 1" Plastic Clean &
Shine (or equivalent), according to manufacturer's instructions. Refer to
www.novuspolish.com
Cautions
–
–
–
–
Refer to
–
Bosch Security Systems
Visually examine the inner and the external surfaces of the bubble for debris, dirt, or
residue. If you must clean the bubble, refer to the steps that follow for instructions.
to order or to find a local distributor.
Do not clean bubbles in the hot sun or on very hot days.
Do not use abrasive or highly alkaline cleaners on the bubble.
Do not scrape the bubble with razor blades or other sharp instruments.
Do not use Benzene, Gasoline, Acetone, or Carbon Tetrachloride on the bubble.
Maintenance, page 78
Installation Manual
Preparing the bubble | en
2023-09-29 | V06 | F.01U.410.315
19
Advertisement
Table of Contents
