Table of Contents
Advertisement
en | Installing a mount power supply box (wall, mast (pole), and corner
22
mounts) - (for non-IR NDP-7602-Z40 camera models)
7
Installing a mount power supply box (wall, mast
(pole), and corner mounts) - (for non-IR NDP-7602-
Z40 camera models)
See sections Recommendations for 24VAC Power Supply and Compatible 24VAC Power
Supplies
Note: Bosch Wall, mast (pole) and corner mounts are only guaranteed to work with Bosch
power supplies.
Before mounting the Power Supply Box, decide if you should wire the box through the holes
in the bottom or back of the box. If wiring the box through the back, move the two (2) seal
plugs to the bottom through the holes before mounting.
Notice!
i
Use ¾ inch (20 mm) NPS fittings for the holes on the bottom and back of the box. Use ½
inch
(15 mm) NPS fittings for the side holes.
Figure 7.1: Power Supply Wall, Mast (pole), and Corner Mounts
1.
2.
Warning!
A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265
!
lb) pull-out force is recommended. The mounting material must be able to withstand this
pull out force. For example, 19 mm (3/4 inch) minimum for plywood.
3.
–
–
2023-09-29 | V06 | F.01U.410.315
Use the wall mount template supplied in the packaging box to locate the four (4)
mounting holes for the power supply box.
Drill four holes for the mounting anchors. If installing outdoors, apply a weatherproof
sealant around each hole at the mounting surface.
Secure the Power Supply Box to the mounting surface.
For a Wall installation: Use four (4) corrosion-resistant, stainless steel studs (not
supplied). Then proceed to Step 5 below.
For a Corner installation: Secure the Corner Plate to the wall corner using four (4)
studs (not included). Then proceed to Step 5 below.
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
