Table of Contents
Advertisement
52
en | Connection
10.3.4
Connecting 24 VAC / 36 VDC power to the camera
Connect 24VAC +/- 10%, 50/60Hz or 36VDC +/- 10% to Connector X105 pins 1 and 2 as in
the figure that follows.
X105 Connector
Pin 1
Pin 2
Note: The AUTODOME camera will generally work with either polarity of 24VAC line/neutral,
and +36VDC and 36VDC_return as long as these lines are not connected to more than one
AUTODOME camera.
Caution!
Compliance with EN50130-4 Alarm Standard - CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
!
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2-6 ms and
a Backup Runtime of greater than 5 seconds for the power level as specified on the
product datasheet.
2023-09-29 | V06 | F.01U.410.315
X104
X105
X106
24 VAC Application
24 VAC Line
24 VAC Neutral
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
36 VDC Application
+36VDC
36VDC_return
Bosch Security Systems
Advertisement
Table of Contents
