Attaching The Pendant Arm To The Power Supply Box - Bosch AUTODOME 7100i Installation Manual

AUTODOME 7100i│AUTODOME 7100i IR
10.3.6

Attaching the pendant arm to the power supply box

Note: Refer to the figure that follows as you complete the steps to attach the pendant arm
to the power supply box.
Notice!
i
You must compress both hinge pins fully to open (unlock) the hinges of the pendant arm.
1.
2.
3.
4.
5.
Warning!
Risk of injury or death
!
Serious injury or death can occur if the hinge pins of the pendant arm are not fully engaged
(locked) to the power supply box. Exercise caution before releasing the pendant arm.
Bosch Security Systems
Push down the lever of the bottom hinge pin on the pendant arm and then rotate the
lever behind the hinge pin stop. The hinge pin stop holds the hinge open while
attaching the pendant arm to the power supply box.
Push up the lever of the top hinge and hold it. Compress both hinge pins completely to
open (unlock) the hinges of the pendant arm before proceeding to the next step.
While holding the top hinge pin open, align the top and bottom hinges of the pendant
arm to their mating points on the power supply box.
After you have aligned the hinges, release the top hinge pin to engage its mating hinge
on the power supply box.
Release the bottom hinge pin from the hinge pin stop to lock the pendant arm to the
power supply box.
Installation Manual
Connection | en
2023-09-29 | V06 | F.01U.410.315
59