Bosch AUTODOME 7100i Installation Manual page 33

AUTODOME 7100i│AUTODOME 7100i IR
8.
9.
10. Tighten the screws.
Notice!
Risk of permanent damage to the camera
i
The interface board connects only one way to the camera. Make sure that when you install
it in the mount (arm or pipe mount), you install it in the correct way like shown in the
above picture.
11. Attach the hook of the camera to the pin on the mount.
12. Tilt the camera until you connect the camera to the mount.
Bosch Security Systems
Put the top cap onto the mount.
Put the three (3) screws back into the top cap.
1
Installation Manual
Installing a pendant arm mount | en
2023-09-29 | V06 | F.01U.410.315
33