AUTODOME 7100i│AUTODOME 7100i IR
1
The table that follows has a list of additional tools and accessories that may be necessary to
complete installation.
Tool / Accessory
Full-size SD card
Small tool (2-3mm
in diameter)
Screwdriver
Ethernet cable
(Cat5e, Cat6, or
better)
Fiber optic cable
SFP module
Bosch Security Systems
Torque wrench with torque
range of 10-12 Nm (90-105 in.-
lb)
Purpose
Record video.
Install an SD card.
Install the ground screw on a pendant
arm mount.
Transmit video and data
Note: Use one of the following types:
–
F/UTP overall screened cable with
unscreened twisted pairs (often
referred to as FTP)
–
S/UTP overall braided shield with
unscreened twisted pairs (often
referred to as STP)
–
Cable with better shielding that
meets the minimum bend radius of
30mm, and maximum diameter of
0.24 inches (6 mm)
Transmit video and data over an extended
range.
Connect a fiber optic cable to the fiber
port on the pendant arm mount or on the
pipe mount (-F models only).
Must use 1Gbps SFP modules.
The fiber used must be compatible with
the SFP modules in mode (single-mode or
multi-mode), wavelengths (850nm or
1310nm) and termination (duplex LC).
The SFP modules used at both the
camera/mount end and at the head-end
media converter must be compatible, if
not the same exact brand and part
number.
Notes:
–
SFP manufacturer is responsible for
reaching the distance claimed for
module.
Installation Manual
Unpacking | en
(user-supplied)
Available from Bosch?
Yes (SD-064G, SD-128G,
or SD-256G)
No
No
No
No
No
2023-09-29 | V06 | F.01U.410.315
15