Memoskop C/ Memoskop C & Mod - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Replacing boards and components
MEMOSKOP C/ MEMOSKOP C & MOD
NOTE
NOTE
Replace the MEMOSKOP .
The attachment screws are accessible on the underside of the storage device.
Check the software status of the MEMOSKOP. Download the system software to the
MEMOSKOP if necessary.
Use the MEMOSKOP Service Software to import the language file.
Set the MEMOSKOP C to the correct video frequency and configure it for the number of
existing monitors. See
configuration for the number of existing monitors / p.
Configure the following parameters in Technical Setup for MEMOSKOP:
© Siemens, 2008
For internal use only
Check the software
MEMOSKOP. If the software status of the MEMOSKOP differs
from that of the system, the system software status must be
downloaded to the MEMOSKOP. The MEMOSKOP software
status can be read out in the 2nd line of the User Setup. The
first number describes the MEMOSKOP type.
CE-100/ C/ C & MOD; 4=C-SUB/ C-SUB & MOD).
Read and record the parameters for MEMOSKOP if you can
select User Setup. After replacing the MEMOSKOP, configure
the MEMOSKOP according to the parameters noted.
(Configuring the video frequency / p. 77)
SPR2-230.840.01.01.02
08.08
status of the
77).
Page 111 of 148
CS PS SP
111
6.15
newly delivered
(2=CE; 3=
and (MEMOSKOP,
SIREMOBIL Iso-C