Page 2
ARTD - 002.731.17..The protective conductor resistance must not exceed 0.2 ohms. Additional notice These instructions apply to retrofitting a video printer on a SIREMOBIL Iso-C only. Parts required • Retrofit kit for installing video printer...
Installing a Video Printer Disconnect the SIREMOBIL Iso-C from the main power supply CAUTION prior to beginning this procedure. If the MS2000 multiformat camera is connected Power cable Videoprinter with 100VAC line voltage: Connect the line wires to transformer T1, connector TI - 34 and TI - 36.
Page 4
This calls the "User Setup menu" for Memoskop. • Call up the "C Documentation" sub-menu. • Perform the configuration on monitor A for SIREMOBIL Iso-C systems with one monitor. • Perform the configuration on monitor B for SIREMOBIL Iso-C systems with two monitors. •...
Installing a Video Printer • Switch the SIREMOBIL Iso-C off and on again to activate the new configuration. For Memoskop C-E (without keyboard) • Switch on the system. • Connect the service PC to the service interface of the SIREMOBIL Iso-C.
Page 6
Installing a Video Printer This page intentionally left blank. SIREMOBIL Iso-C Register 3 SPR2-230.033.02 Page 6 of 6 Siemens AG Rev. 02 10.99 TD SD 24 Medical Engineering...