Removing The Belt Roller - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Roller > Procedure

Removing the Belt Roller

■ Preparation
1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Open the Front Cover.
7) Remove the Inner Cover (Upper).(Refer to page 4-22)
8) Remove the Process Upper Guide Unit.(Refer to page 4-78)
■ Procedure
CAUTION:
• Avoid deformation of the 2 Process Upper Guides [1] and the 4 Paper Guides [2].
• Put the removed Process Upper Guide Units [3] with the Belt Controller Unit [4] side
up. Place a stack of paper (approx. 2 cm thick) or cardboards [6] under the handle [5]
to make it stabilized.
[1]
[3]
[1]
[6]
[5]
[2]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Roller > Procedure
[3]
[2]
[4]
1) Remove the 2 Delivery Guides (Lower) [1] and the 2 Lower Delivery Guides [2].
• 8 Claws [3]
2) Remove the 2 Belt Rollers [1] and the 2 Delivery Roller Shafts [2].
CAUTION:
Be careful when installing/removing the 2 Delivery Roller Shafts [2] because they can
fall.
F-4-202
[2]
[3]
[3]
[2]
[2]
[1]
[1]
4-85
[1]
F-4-203
F-4-204
4-85