Attaching The Labels - Canon Finisher-AK1 Service Manual

6) Loosen the 2 screws on the Latch Plate (Rear).
7) If the value obtained at "Checking Adjustment Value" is "+ (positive)", move it in [A]
direction and tighten the 2 screws.
If the value obtained at "Checking Adjustment Value" is "- (negative)", move it in [B]
direction and tighten the 2 screws.
CAUTION:
Perform adjustment so that the total of the shifting amount (scale) of the Latch Plate
(Front/Rear) is within -2 to +2 mm.
[A] [B]
8) Reconnect the Finisher with the upstream equipment.
9) Turn ON the power of the finisher then the host machine.
10) Check the adjustment value again.
If the adjustment value indicated on the LED (DSP381) is within the range, press ENTER
button (SW385) to complete the adjustment mode.
If the adjustment value indicated on the LED (DSP381) is out of the range, execute
adjustment for the second time. Adjustment can be considered OK to complete if the value
gets closer to the adjustment range (estimated value).
11) Put the DIP switch setting back and install the removed covers/parts.
7
Installation > Attaching the Labels
Screw
F-7-119
7 Installation > Attaching the Labels

Attaching the Labels

1) Open the Finisher Front Cover.
2) Install the Guide Map Label inside the Finisher Front Cover. (The figure shown is the
Saddle Finisher.)
• 7 Claws
Guide Map Label
3) Install the Staple Label inside the Front Cover.
• 4 Claws
Staple Label
Claw
Claw
Claw
F-7-120
Claw
Claw
F-7-121
7-42
7-42