Canon Finisher-AK1 Service Manual page 344

2) Install the Positioning Pin.
• 2 Screws (RS tightening; M4x10)
x2
7
Installation > Installation Procedure > Connecting with the Document Insertion Unit
F-7-77
7 Installation > Installation Procedure > Connecting with the Document Insertion Unit
3) Lift the Latch Plate (Front) up and lock it on the cover, and connect the Finisher and the
Document Insertion Unit by fitting the Positioning Pin of the Document Insertion Unit into
the hole on the Positioning Plate of the Finisher.
< Front side >
Latch Plate (Front)
< Rear side >
Positioning Pin Hole
7-28
F-7-78
F-7-79
7-28