Connecting The Cable - Canon Finisher-AK1 Service Manual

Connecting the Cable

NOTE:
This item is also variably connected to other option machine, but as an example, in this
case, it is connected to the host machine.
CAUTION:
• Be sure to turn the knob of the ARCNET Cable all the way to connect otherwise it
can cause unstable electrical contact.
• Be sure the power-off of the host machine and the unplugged power plug before
connecting the ARCNET cable.
1) Rotate the Terminal Connector at the back of the host machine in the direction of the arrow
to remove.
NOTE:
Trailing edge connector is not used in the Professional Puncher Integration Unit.
7
Installation > Installation Procedure > Connecting the Cable
F-7-84
7 Installation > Installation Procedure > Connecting the Cable
2) Connect the ARCNET Cable to the terminal at the back of the host machine, and then
rotate the knob in the direction of the arrow to fix.
3) Connect the Terminal Connector and the ARCNET Cable to the Coaxial Connector, and
turn their knobs in the direction of the arrows as shown in the figure to secure
x2
ARCNET Cable
7-30
F-7-85
Terminal
Connector
Coaxial Connector
F-7-86
7-30