Canon Finisher-AK1 Service Manual page 341

2) Install the Positioning Pin.
• 2 Screws (RS tightening; M4x10)
x2
3) Lift the Latch Plate (Front) up and lock it on the cover, and connect the Finisher and the
Perfect Binder by fitting the Positioning Pin of the Perfect Binder into the hole on the
Positioning Plate of the Finisher.
< Front side >
Latch Plate (Front)
7
Installation > Installation Procedure > Connecting with the Perfect Binder
F-7-68
F-7-69
7 Installation > Installation Procedure > Connecting with the Perfect Binder
< Rear side >
Positioning Pin Hole
4) Lower the Latch Plate (Front) and fix it.
• 1 Screw (Use the Screw removed in the step 7) of "Before Installing the Finisher")
5) Close the Finisher Front Cover.
7-25
F-7-70
Latch Plate (Front)
Screw
F-7-71
7-25