Setting Of Pressless Mode - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Setting of Pressless Mode > Procedure

Setting of Pressless Mode

Execute this adjustment to eliminate paper wrinkle.
Adjusting method is as follows:
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Auxiliary Adjustment > Setting of Pressless Mode > Procedure
ENTER
F-5-291
2) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
3) Press push switch SW384 [1] to execute setting.
• 0: normal
• 1: no press (when using thin paper)
• 2: not used
• 3: no intermittent feeding
4) Press switch SW385 [1] again to complete this adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
[1]
F-5-292
ENTER
[1]
F-5-293
5-120
5-120