Canon Finisher-AK1 Service Manual page 356

■ Side Rregistration Adjustment
1) Execute shutdown sequence, and then turn OFF the power of the host machine and
Finisher.
2) Separate the Finisher from the upstream equipment.
• Disconnect the power plug from the outlet.
• Disconnect the power cable of the finisher.
• Disconnect the ARCNET cable.
• Remove the shunt cable.
• Remove the Latch Receivers (Front and Rear)
3) Loosen the 2 screws on the Positioning Plate at the right side.
4) If the value obtained at "Checking Adjustment Value" is "+ (positive)", move it in [A]
direction and tighten the 2 screws.
If the value obtained at "Checking Adjustment Value" is "- (negative)", move it in [B]
direction and tighten the 2 screws.
Screw
7
Installation > Adjustment > Side Registration/Skew Adjustment > Skew Adjustment
[B] [A]
F-7-113
7 Installation > Adjustment > Side Registration/Skew Adjustment > Skew Adjustment
■ Skew Adjustment
CAUTION:
If the skew adjustment value is within the range, start from step 8).
1) Remove the 3 Knobs.
• 3 Claws
Knob
CAUTION:
When the One-way Clutch inside the knob is removed, be sure to install it in the
direction where the arrow marking of the One-way Clutch is visible.
7-40
Claw
F-7-114
F-7-115
7-40