6.2.2.9
Transferring the trace configuration from the drive to the project
Overview
The following describes how you can transfer a trace configuration into the project.
Requirements
• An online connection has been established to the drive.
• A trace is saved in the drive.
Procedure
Proceed as follows to transfer a trace configuration to the project:
1. Open a trace in the drive (see Chapter "Creating or calling a trace (Page 318)").
2. If required, activate the icon
3. Click on icon
The configuration is transferred as new trace configuration into the
A trace configuration with the same name in the system folder is overwritten.
6.2.2.10
Deleting a trace configuration
Overview
The following describes how you can delete a trace configuration in the drive.
Requirements
• There is an online connection to the drive unit.
• A trace is saved in the drive.
Procedure
To delete a trace configuration in the drive, proceed as follows:
1. Open a trace configuration in the drive (see Chapter "Creating or calling a trace (Page 318)").
2. If required, activate the icon
3. Click on icon
A confirmation prompt opens.
4. To confirm the deletion, in the query, click on "Yes".
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
for monitoring.
to transfer the trace configuration from the drive into the project.
for monitoring.
to delete the selected trace configuration.
Diagnostics
6.2 Diagnostics via Startdrive
"Traces" system folder.
327