Diagnostics
6.2 Diagnostics via Startdrive
Requirement
• With a double-click a new trace configuration is created and selected in the project tree.
Selecting and configuring signals
Note
Maximum number of signals
You can configure a maximum of 8 signals per trace.
To configure the signals to be recorded, proceed as follows:
1. Click on the first empty cell in the "Name" column.
2. Select a signal. The following options are available:
– In the "Name" column, click on the icon
– Enter the parameter name in the "Name" column - or part of the name in the cell. The
– To see the selection of parameters from all drive objects of the drive unit, put an asterisk
3. If you wish to assign another color to the signal, then select another color from the drop-
down list in the "Color" column.
4. Click in the "Comment" column and enter a comment for the signal.
5. Repeat the procedure from step 1 until all of the signals to be recorded have been entered
into the table.
320
field shows the possible parameters in the drop-down list.
and a period - "*." - in front of the search term, e.g. "*.r0063".
The "Address" column shows the parameter number. A color is recommended in the
"Color" column.
and select a parameter.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2