Siemens SINAMICS S120 Commissioning Manual page 134

Commissioning
5.3 Creating a project offline
Restrictions
• Command option "Paste" is not listed for Control Units that do not belong to the
SINAMICS S120 product category (e.g. G150).
• The procedure is not possible under a SIMATIC Drive Controller.
Procedure (project tree)
Proceed as follows, to copy and insert a configured Motor Module within the project tree.
1. Select the Motor Module to be copied.
2. Open the shortcut menu and click on command "Copy" <Ctrl+C>.
3. Select the drive in which the Motor Module should be inserted.
4. Open the shortcut menu and click on command "Paste" <Ctrl+V>.
The Motor Module is inserted at the intended location.
5. If you wish to insert the copied Motor Module several times into the same drive, then after
insertion, immediately rename the Motor Module using <F2>.
Otherwise, an error message is displayed when inserting the next time. In this case, proceed
as follows:
– In this case, select option "Rename and paste objects"
Procedure (device view)
Proceed as follows, to copy and insert a configured Motor Module within the device view.
1. Activate the "Device view" tab in the device navigation of the drive.
2. Select the Motor Module to be copied.
3. Open the shortcut menu and click on command "Copy" <Ctrl+C>.
4. If you wish to insert the Motor Module in the same drive, then click in the working area.
5. Open the shortcut menu and click on command "Paste" <Ctrl+V>.
The Motor Module is inserted at the intended location.
OR
132
The Motor Module is then automatically renamed and inserted at the intended location.
①
and confirm with "OK"
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
②
.