Table of Contents
Advertisement
6 Transport and storage
▶
Observe the transport instructions on the packaging.
▶
During storage and transport, the environmental conditions specified in
chapter 16 "Technical data" must be observed.
▶
If the packaging has to be opened e.g. for inspection purposes, you should reseal
the packaging to the condition in which it was supplied.
▶
Ensure that the hydraulic power unit is only transported in an upright position.
6.1 Transporting the hydraulic power unit
Falling, tumbling or uncontrolled position change of the hydraulic power unit!
Risk of injury! Damage to property!
▶
Use the original packaging of the hydraulic power unit for transport.
▶
Check the weight of the hydraulic power unit.
▶
Make sure that the hydraulic power unit cannot fall due to its decentralized
center of gravity.
▶
Transport the hydraulic power unit using a floor conveyor or suitable lifting gear.
▶
For fixation and lifting of the hydraulic power unit with lifting gear, only use the
intended eyebolts.
▶
Transport the hydraulic power unit in an upright position using a floor conveyor.
▶
Observe the maximum load-bearing capacity of the attachment devices and
floor conveyors.
▶
Never step or reach below suspended loads.
▶
Wear personal protective equipment, e.g. safety shoes.
▶
Ensure that no unauthorized persons are within the danger zone.
▶
Comply with the national laws and regulations regarding occupational health
and safety and transport.
Heavy loads with a weight of more than 15 kg!
Risk of injury! Risk of health hazards! Damage to property!
▶
Use a forklift or suitable lifting gear e.g. lifting slings or lifting straps to
transport the hydraulic power unit.
▶
During transport, secure the hydraulic power unit against falling.
▶
Carefully position the hydraulic power unit on the contact surface to prevent
any damage.
Transport and storage 55/128
WARNING
CAUTION
CytroBox, RE 51057-B/11.19, Bosch Rexroth AG
Advertisement
Table of Contents
