Transport And Storage; Transporting Hydraulic Power Units - Bosch Rexroth RE 07009-MON General Assembly Instructions

8/20 Bosch Rexroth AG
WARNING!
WARNING!
Assembly Instructions for Hydraulic Power Units | RE 07009-MON/11.17

5 Transport and storage

Observe the transport instructions, e.g. on the packaging.
f
When storing and transporting the product, always observe the ambient
f
conditions specified in Chapter 15 "Technical data".
If the package has to be opened e.g. for inspection purposes, you should
f
reseal the packaging to the condition in which it was supplied.
Wherever possible, the packaging should not be removed until directly before
f
assembling the unit.
5.1

Transporting hydraulic power units

Danger to life due to tumbling, falling or uncontrolled movement of the
hydraulic power unit!
If not transported appropriately, the hydraulic power unit may lose its stability and
thus be knocked over, fall or move in an uncontrolled way.
Check the weight and also the location of the center of gravity of the hydraulic
f
power unit.
Place the product on a suitable foundation / on suitable ground.
f
By means of additional suitable measures (e.g. by securing holding down
f
points or with the use of cranes) provide for sufficient stability before removing
any packing/transit materials or fixtures.
Only the intended locations and attachment points should be used for securing
f
or lifting the hydraulic power unit.
Hydraulic power units must never be attached to or lifted at the mounted
f
components (piping, hoses, manifolds, electric motors, accumulators, etc.).
Observe the maximum load-bearing capacity of the attachment devices.
f
Observe the maximum load-bearing capacity of the floor conveyors.
f
Ensure that no unauthorized persons are within the hazard zone.
f
Danger to life due to the ejection of high-pressure oil or machine
malfunctions during operation!
In the case of improper transport of the hydraulic power unit, pressurized or
functional components may become damaged.
Ensure that these components do not come into contact with the attachment
f
devices or lifting tools during transport.
Ensure that hydraulic power units are not attached to or lifted at
f
these components.