Transport And Storage - Bosch Rexroth CytroPac Operating Instructions Manual

22/80 CytroPac | Transport and storage
Bosch Rexroth AG, Edition 07.2022, RE 51055-B

6 Transport and storage

▶ Observe the transport instructions on the packaging.
▶ During storage and transport, the environmental conditions specified in
data sheet 51055 must be observed, see chapter 1.2 "Required and amending
documentation".
▶ If the packaging has to be opened e.g. for inspection purposes, you should
reseal the packaging to the condition in which it was supplied.
▶ Ensure that the hydraulic power unit is only transported in an upright position.
6�1 Transporting the hydraulic power unit
Falling, tumbling or uncontrolled position change of the hydraulic power unit!
Risk of injury! Damage to property!
▶ Use the original packaging of the hydraulic power unit for transport.
▶ Check the weight of the hydraulic power unit.
▶ Make sure that the hydraulic power unit cannot fall due to its decentralized
center of gravity.
▶ Transport the hydraulic power unit using a floor conveyor or suitable lifting
gear.
▶ For fixation and lifting of the hydraulic power unit with lifting gear, only use
the intended eyebolt.
▶ Transport the hydraulic power unit in an upright position using a floor conveyor.
▶ Observe the maximum load-bearing capacity of the attachment devices and
floor conveyors.
▶ Never step or reach below suspended loads.
▶ Wear personal protective equipment, e.g. safety shoes.
▶ Ensure that no unauthorized persons are within the danger zone.
▶ Comply with the national laws and regulations regarding occupational health
and safety and transport.
Damage to pressurized and functional components!
Risk of injury! Damage to property!
▶ During transport, make sure that these components do not come into contact
with attachment devices and lifting gear.
▶ Ensure that the hydraulic power unit is not attached or lifted at these
components.
WARNING