Setting the IP address using the operating unit
To set the IP address using the operating unit (see Fig. 1 on page 24), proceed as
follows:
▶
Switch on the control voltage of the drive controller.
▶
Press the "Enter" key on the operating unit.
▶
Using the ▲/▼ keys, select "Ethernet" and confirm your selection with the "Enter"
key.
▶
Now use the ▲/▼ keys to select the interface which is connected and which you
would like to configure (e.g. X22).
▶
Now select the address which you would like to configure and/or check:
– IP address
– MAC address
– Gateway address
– Network mask (subnet mask)
The individual octets are accepted by pressing the "Enter" key. You can always get
back with the "ESC" key.
Commissioning 81/128
CytroBox, RE 51057-B/11.19, Bosch Rexroth AG