Table of Contents
Advertisement
Heavy loads with a weight of more than 15 kg!
Risk of injury! Risk of health hazards! Damage to property!
▶ Use a forklift or suitable lifting gear e.g. lifting slings or lifting straps to
▶ During transport, secure the hydraulic power unit against falling.
▶ Carefully position the hydraulic power unit on the contact surface to
6�1�1 Preparing for transport
Prior to transport, make the following preparations:
▶ Check the space required for installation of the hydraulic power unit at the
▶ Check the transport route.
▶ Depending on the type of transport, ensure additional space besides and
Transport after
▶ For transportation after operation, drain the hydraulic fluid from the oil tank.
previous operation
6�1�2 Transport using forklifts and similar floor conveyors
To transport the hydraulic power unit using a forklift, proceed as follows:
1� Move the fork of the forklift under the packaging of the hydraulic power unit or
2� Carefully lift the load for checking the center of gravity position.
3� Make sure that the hydraulic power unit cannot move out of the intended
4� Secure the hydraulic power unit against the occurring acceleration forces and
5� During transport, only lift the hydraulic power unit as far off the floor as
transport the hydraulic power unit.
prevent any damage.
place of use.
above the hydraulic power unit.
To prevent air in the suction line, a low level of hydraulic fluid is always
inside the tank.
under the hydraulic power unit secured for transport.
Ensure a stable center of gravity position.
position.
the related undesired motion of the hydraulic power unit.
necessary for transport.
Transport and storage | CytroPac
CAUTION
RE 51055-B, Edition 07.2022, Bosch Rexroth AG
23/80
Advertisement
Table of Contents
