Disk Access Delay Time
Press t or s to select "Init Disk Access
Delay", then press ENT. The current
setting will be displayed on the LCD.
Press t or s to select between 5 and 75
seconds or "No delay", then press ENT
for two seconds.
Every time you change this setting, you must reset
the controller for the changes to take effect.
Refer to Chapter 3 section "Disk Access Delay
Time" for more information.
Tag Command Queuing
Firmware
2.11
now
command queuing with an adjustable
maximum tag count from 1 to 128. The
default setting is Tag Command Queuing
Enabled with a maximum tag count of 32.
This setting can be changed or tag
command queuing can be disabled. From
the Main Menu, select "View and Edit
Configuration Parameters." Then select
"Drive-side SCSI Parameters." Press t
or s to select "Maximum Tag Count,"
then press <ENT>. The current setting
will be displayed on the LCD.
Press t or s to select between 1 and
128 seconds or "Disable", then press
<ENT>. for two seconds.
116
Init Disk Access
Delay - 15secs..
Init Disk Access
delay -
supports
tag
Maximum Tag
Count - 32
Maximum Tag
Count - 128
5secs..
..
..
User's Guide