Setting A Scsi Channel's Primary Id / Drive Channel - Acer AcerAltos 3102RS User Manual

Setting a SCSI Channel's Primary ID / Drive Channel

Press ENT for two seconds to enter the
Main Menu. Press t or s to select "View
and Edit SCSI Channels", then press
ENT.
SCSI channel information
displayed on the LCD. Press ENT on the
drive channel you wish the SCSI ID
changed.
Press t or s to select "Set SCSI
Channel Primary ID", then press ENT.
The current Primary SCSI ID will be
displayed on the LCD. Press t or s to
change the current SCSI ID, then press
ENT for two seconds.
Every time you change a channel's SCSI ID, you
must reset the controller for the changes to take
effect.
The default SCSI ID of the Host channel is 0, the
Drive channel is 7.
If only one controller exist, you must set the
Secondary Controller's SCSI ID to "NA". If a
secondary controller exist, you need to set a
SCSI ID.
Multiple SCSI ID can be applied to the Host
channel while the Drive channel, one SCSI ID or
no SCSI ID.
Multiple SCSI ID is supported in firmware version
2.11 or later. Firmware versions earlier than 2.11
only supports one SCSI ID.
At least a controller's SCSI ID has to be present
on the SCSI bus.
Chapter 7 General Front Panel Operation
View and Edit
SCSI Channels
will be
CH1=Drive
SID=NA SXF=20.0M
Set SCSI Channel
Primary ID
Set Pri. Ctlr
ID= 7 to ID: 8 ?
×
PID=7
..
103