Kenwood NX-5000 Series Function Reference page 83

1 DMR CONVENTIONAL SYSTEM
1.15 Sending GPS Data
The ID of the Target Transceiver (GPS Base ID)
GPS Base ID is the ID of the target transceiver used for sending GPS data.
By using KPG-D1/ D1N, either Unit ID or Group ID can be configured as GPS Base ID. The ID of the base station which is
responsible for operation and administration of system is normally configured.
Note
If GPS Base ID is not configured, GPS data is sent to the Base ID to which data such as a Status Message and Short
Message is to be sent. (Refer to
Configuration using KPG-D1/ D1N
Configuring GPS Base ID Type and GPS Base ID (
Conventional > GPS > DMR)
Sending GPS Data Automatically at Certain Intervals (GPS Report Mode)
GPS data can be sent automatically at the intervals configured in GPS Report Interval Time.
This function is used for controlling or monitoring vehicles on a time basis by periodically sending location information to the
base station.
To use this function, "Auto" must be configured for GPS Report Mode by using KPG-D1/ D1N.
Note
The transceiver sends the GPS data upon receipt of the GPS data transmission request from the base station even if
0
"Auto" is configured for GPS Report Mode.
If the transceiver is under the following conditions, the automatic transmission of GPS data at certain intervals will be
0
canceled. The transceiver suspends transmission for the period of time configured for Transmit Busy Wait Time, to
avoid collisions with GPS data transmissions by other transceivers. A transmission is canceled when the channel is busy
and the Transmit Busy Wait Time elapses. (Refer to
While the transceiver is transmitting
0
While the transceiver is in busy state
0
While the transceiver unmutes the speaker
0
While the Public Address function is used (Mobile only)
0
If the transmit frequency is not configured
0
While transmission is disabled by the Time-out Timer
0
While the transceiver is sending or receiving the DMR data
0
Transceiver Password Mode
0
Emergency Mode
0
Configuration using KPG-D1/ D1N
Configuring GPS Report Mode (
DMR FUNC (K, F)/Ver 2.20
Base ID.)
Transceiver Settings > Personal > Personal Features > DMR
Transmit Busy Wait
Transceiver Settings > Personal > Personal Features > DMR Conventional > GPS)
Time.)
CONTENTS INDEX
66