Kenwood NX-5000 Series Function Reference page 20

1 DMR CONVENTIONAL SYSTEM
1.1 Initiating Voice Communications (Basic Transmission and Reception)
Auto Reset Timer
Auto Reset Timer is the amount of time from when the received Unit ID or Group ID matches the Unit ID or Group ID
preconfigured for the transceiver until the LCD, blinking of LED and emission of Alert Tone will automatically be reset.
By using KPG-D1/ D1N, Auto Reset Timer can be configured. Also, how the transceiver behaves after the amount of time
configured in Auto Reset Timer elapses can be configured.
Whether different Auto Reset Timer configurations are applied to voice communications and data communications can be
configured.
Configuration
Off
Auto Reset Timer
(Voice or Message)
0 sec to 300 sec
LED (Voice only)
Alert Tone (Voice or Message)
LCD (Voice or Message)
Configuration using KPG-D1/ D1N
0
Configuring Auto Reset Timer (Voice) (
> Voice)
0
Configuring Auto Reset Timer (Message) (
Reset > Message)
Selective Call Alert LED
Selective Call Alert LED is the function to make the LED flash when the transceiver receives a call using a DMR ID.
A user can notice by the LED that the transceiver is receiving a call.
One of the 7 colors can be used to make the LED flash, and the flashing color can be configured for each type of call.
Yellow
0
Purple
0
Blue
0
Light Blue
0
Red
0
Green
0
White
0
Configuration using KPG-D1/ D1N
0
Configuring Selective Call Alert LED (
0
Configuring Alert LED Color (
0
Configuring Alert LED Color (Individual ID List) (
Color)
0
Configuring Alert LED Color (Group ID List) (
DMR FUNC (K, F)/Ver 2.20
Table 1-1 Auto Reset Timer
Auto Reset Timer will not be activated.
After the configured time elapses, the matching state of the Unit ID or Group ID
is automatically reset.
If this function is enabled, the flashing LED for the Selective Call Alert LED
turns off when the length of time configured in Auto Reset Timer elapses.
If this function is enabled, the intermittently emitted Alert Tone stops when the
length of time configured in Auto Reset Timer elapses.
While this function is enabled, the flashing LED for the Optional Signaling
LED turns off, and the display will change from one of the following displays to
the previous channel display if the amount of time configured for Auto Reset
Timer elapses.
ID display after receiving an Individual Call or Group Call
0
Status Message display after receiving a Status Message
0
Short Message display after receiving a Short Message
0
Transceiver Settings > DMR > DMR Information > General > Auto Reset
Transceiver Settings > DMR > DMR Information > General > Auto
Transceiver Settings > DMR > DMR Information > Conventional)
Transceiver Settings > DMR > DMR Information > Conventional > Alert LED Color)
Transceiver Settings > DMR > Individual ID List > Alert LED
Transceiver Settings > DMR > Group ID List > Alert LED Color)
Description
CONTENTS INDEX
3