Kenwood NX-5000 Series Function Reference page 80

1 DMR CONVENTIONAL SYSTEM
1.14 Terminating Voice Communications by a Transceiver Other Than the Transmitting Transceiver (Call Interruption)
0
Transmission using the Interrupt Message Call function
The Interrupt Message Call function can be used to send a Call Interruption request message before sending a message
to end voice communication.
1
Send a message during voice communication.
"Interrupt" appears on the display, and a Call Interruption request message
is sent to all IDs.
Note
When message sending operation is performed while receiving a signal
encrypted in the AES/ DES, DES (Built-in DES) or Enhanced Encryption
format, Busy Tone 2 (3 beeps) is emitted from the transceiver and "Busy"
appears on the display for 1 second. A Call Interruption request message
is not sent in this case.
2
Transmission of Call Interruption request message is complete.
When there is no more signal, "Send Data" appears on the display and the
message is sent.
Note
If the signal persists even after transmission of the Call Interruption
request message is complete, Busy Tone 2 (3 beeps) is emitted from the
transceiver and "Busy" appears on the display for 1 second.
DMR FUNC (K, F)/Ver 2.20
Z o n e 1
C h a n n e l 1
I n t e r r u p t
Menu Zone+
Z o n e 1
C h a n n e l 1
S e n d D a t a
Menu Zone+
CONTENTS INDEX
12 : 34 A
M
12 : 34 A
M
63