Kenwood NX-5000 Series Function Reference page 62

1 DMR CONVENTIONAL SYSTEM
1.10 Sending and Receiving a Status Message (Status Call)
Status List
To use a Status Message, the status to be sent must be preconfigured in the transceiver by using KPG-D1/ D1N prior to
the transmission. A maximum of 1024 statuses can be configured in the Status List.
Configuration
The status number can be configured. A status number can be configured in the range between
Status
0 and 1023.
The status name can be configured. It is not easy to recognize the meaning of a status only by
viewing a status number. In this case, a user can link the status number to a short message; hence,
it can be easily understood. A maximum of 16 characters can be configured.
Status Name
If the status number is configured in the Status List, the Status Name appears when the transceiver
receives a Status Message. If the transceiver receives a status that is not configured in the Status
List, the status number appears on the transceiver display.
The permission or inhibition of transmission of status can be configured.
The status for which Transmit Inhibit is enabled does not appear on the status selection display
Transmit Inhibit
in Status Mode. In this case, a user cannot select a status for which Transmit Inhibit is enabled
in Status Mode.
The type of tone sounding from the transceiver can be configured for a received status number
Alert Tone
from the status numbers registered in the Status List.
Voice guidance of when the transceiver receives a status can be configured for each status.
If the transceiver receives a status for which voice guidance is configured, the voice guidance is
Voice Announcement executed. If Alert Tone is enabled, voice guidance is executed after an Alert Tone is emitted.
To configure voice guidance for Voice Announcement, "User Programmable" needs to be
configured in Voice Announcement Type.
Configuration using KPG-D1/ D1N
0
Configuring Status List (
0
Configuring Voice Announcement Type (
Voice Announcement)
Status Message Stack
Status Message Stack is the function to store a Status Message in the stack memory. Up to 250 Status Messages and
Caller IDs in total can be stored in the stack memory of the transceiver.
If a message is stored in the transceiver, the "
Message if the transceiver enters Stack Mode. (Refer to Common FUNC
Configuration using KPG-D1/ D1N
Configuring Status Message Stack (
DMR FUNC (K, F)/Ver 2.20
Table 1-12 Status List
Transceiver Settings > DMR > Status List)
Transceiver Settings > Optional Features > Optional Features 1 >
" icon blinks as notification. In this case, a user can read the stored Status
Transceiver Settings > DMR > DMR Information > General > Stack)
Description
Viewing the Receive History
CONTENTS
(Stack).)
45
INDEX