General Information; Pushing The Traction Unit - Toro Groundsmaster 360 Service Manual

General Information

Pushing the Traction Unit

Hydraulic System: General Information
The Operator's Manual provides information regarding the operation, general
maintenance procedures, and maintenance intervals for your machine. Refer to
the Operator's Manual for additional information when servicing the machine.
In case of emergency, the machine can be pushed for a very short distance.
However, Toro does not recommend this as a standard procedure.
g036057
1. Transmission
1. Ensure that the engine is not running.
2. Find the 2 bypass valves on the transmission
valves (rotate them counterclockwise) 1 to 2 turns.
Pushing the machine faster than 2 mph can damage the drive
system. If you must move the machine a considerable distance
(more than a few feet), transport it on a truck or trailer.
3. Slowly push the machine.
Do not start the engine when the bypass valves are open or
transmission damage will occur.
4. Before you start the engine, tighten the 2 bypass valves to close them; torque
the valves to 7 to 9 N∙m (62 to 79 in-lb).
Figure 19
2. Bypass valve
IMPORTANT
IMPORTANT
Page 4–4
(Figure 19). Loosen the 2
Groundsmaster 360
16225SL Rev C