Toro Groundsmaster 360 Service Manual page 420

Removing the Hood
Installing the Hood
Chassis: Service and Repairs
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Unlatch the hood and raise it.
3. Remove the hairpin cotter (item 15 in
4. Slide the hood to the left side of the machine to free the hood support from
the frame rods.
5. Remove the hood from the machine.
6. If necessary, remove the hood components
7. Check the condition of all the seals on the frame and hood. Replace all
seals that are damaged or missing.
If there is a significant amount of unwanted material on the radiator,
verify the sealing of the radiator area.
1. Install all the hood components that were removed
Note: If the intake screen was removed from the hood, ensure that the hood
mount assembly (item 9 in
install the screen. Secure the screen to the hood with the 27 plastic plugs.
2. Check that no gaps exist between the hood components and the hood. If any
gaps are found, seal them with silicone sealant.
3. Position the hood to the machine and slide the hood support onto the frame
rods.
4. Secure the hood to the machine with the hairpin cotter (item 15 in
5. Close the hood and latch it.
Figure
IMPORTANT
Figure 302) is attached to the hood before you
Page 6–68
302) from the left side frame rod.
(Figure 302).
(Figure 302).
Figure
Groundsmaster 360
16225SL Rev C
302).