Toro Groundsmaster 360 Service Manual page 203

Removing the Steering Control Valve
Groundsmaster 360
16225SL Rev C
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
g036306
1. O-ring
2. Straight fitting
3. O-ring
g036307
1. Out port (T)
2. Load sensing port (E)
3. Right turn port (R)
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
3. For assembly purposes, label all the hydraulic lines and fittings at the
steering control valve. Note the port designations on the steering control
valve (Figure 143).
CAUTION
Releasing Pressure from the
4–5).
Figure 142
4. O-ring
5. Straight hydraulic fitting (4 each)
Figure 143
4. In port (P)
5. Left turn port (L)
4–68).
Page 4–145 Hydraulic System: Service and Repairs