Deck Lift Switch - Toro Groundsmaster 360 Service Manual

Deck Lift Switch

Testing the Deck Lift Switch
Groundsmaster 360
16225SL Rev C
g036823
1. Control panel
g037935
The deck lift switch is used to raise or lower the cutting deck. The deck lift switch
is located on the control panel
The engine must be running to allow the cutting deck to be raised or lowered.
When the front of the lift switch is pressed, the deck will lower fully. When the
rear of the lift switch is pressed and held, the deck will raise. When raising the
deck, the deck will remain in position if the switch is released.
Note: To raise or lower the deck, the seat has to be occupied. Also, to lower the
cutting deck, the engine must be in running condition.
The Toro Electronic Controller (TEC) monitors the operation of the deck lift switch.
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. Before you disconnect the deck lift switch for testing, ensure that you test
the switch and its circuit wiring as a TEC electrical input with the InfoCenter
display; refer to Using the InfoCenter Display for Troubleshooting (page
5–30).
3. If the InfoCenter verifies that the deck lift switch and circuit wiring are
functioning correctly, no further switch testing is necessary.
4. If the InfoCenter determines that the deck lift switch and circuit wiring are not
functioning correctly, proceed with the test.
5. Remove the control panel to get access to the deck lift switch; refer to
Disassembling the Control Console (page
Figure 207
2. Deck lift switch
Figure 208
(Figure 207).
6–54).
Page 5–63 Electrical System: Testing the Electrical Components