Toro Groundsmaster 360 Service Manual page 410

Removing the Power Center Assembly
Installing the Power Center Assembly
Chassis: Service and Repairs
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, shut off the engine, and remove the key from the key switch.
2. Disconnect the battery cables from the battery. Remove the negative battery
cable and then remove the positive cable; refer to
(page 5–110).
3. Remove the operator seat from the machine; refer to
Seat (page 6–60).
4. Unlatch and remove the cover panel (item 24 in
5. To access the machine components below the power center assembly, do
the following:
A. Remove the screws that secure the center tray assembly (item 15 in
Figure 296) to the power center.
B. Remove the flange-head screws that attach the power center housing
(item 21 in Figure
the machine.
C. Carefully raise and support the power center tray with all attached
electrical components to get access below the power center.
6. If complete removal of the power center tray is necessary, do the following:
A. For assembly purposes, label all the wire harness connectors.
B. Disconnect all the wire harness connectors from the electrical
components attached to the power center tray.
C. Carefully separate wire harness from power center tray and electrical
components on tray. Remove power center tray from machine.
1. If the power tray was removed, do the following:
A. Carefully position the electrical harness to the center tray components
and install the center tray to the machine.
B. Connect all the wire harness connectors to the components on the power
center.
2. Place the power center housing to the machine. Secure the tray to the
housing and then the housing to the cab platform.
3. Install and secure the cover panel with the 4 swell latches (item 1 in
296).
4. Install the operator seat; refer to
5. Connect the battery cables to the battery. Connect the positive cable and
then connect the negative cable; refer to
296) to the cab platform. Remove the housing from
Installing the Operator Seat (page
Servicing the Battery (page
Page 6–58
Servicing the Battery
Removing the Operator
Figure 296).
Figure
6–61).
5–110).
Groundsmaster 360
16225SL Rev C