AMAX panel 2000 / AMAX panel 2000 EN
3.
4.
5.5
Date and Time Fail
Condition:
Date and time is not set after the system is powered on.
Restore:
Date and time is programmed and the fault is reset. Refer to Section 3.1.1 Setting date and
time for more information.
Supervise:
1.
2.
3.
5.6
Communication Failure
The zone indicator 6 lights to indicate Communication Failure. Enter [6] to step to
Communication failure list for more information.
5.6.1
Communication Failure 1
Condition:
Panel can not send the report to the Destination 1 after 4 attempts.
Restore:
The fault is reset when the first kissoff tone is received and fault is reset.
Supervise:
1.
2.
3.
5.6.2
Communication Failure 2
Condition:
Panel can not send the report to the Destination 2 after 4 attempts.
Restore:
The fault is reset when the first kissoff tone is received and fault is reset.
Supervise:
1.
2.
3.
5.6.3
Communication Failure 3
Condition:
Panel can not send the report to the Destination 3 after 4 attempts.
Restore:
Bosch Sicherheitssysteme GmbH
Slow flash FAULT indicator (refer to the detailed description in chapter keypad
indicators)
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault
No report on the date and time fault.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators)
No report to the control panel system when date and time setting is recorded in non-
volatile memory and Control Panel is reset. The FAULT indicator is turned off when there
is no other system fault.
Report the fault to configured destination on location 140 when the fault is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Report the fault to configured destination on location 140 when the fault is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Installation Manual
Fault and Tamper Description | en
F.01U.241.127 | V4 | 2011.12
35