Walk Test Mode; Event Memory Recall Mode - Bosch AMAX panel 2000 Installation Manual

AMAX panel 2000 / AMAX panel 2000 EN
3
4
5
6
7
8
4.4

Walk test mode

This function allows code holders to test detection devices to ensure they are functioning
correctly. Before activating Walk test Mode, bypass any zones that are not required for
testing.
During the walk test, no walk test report is sent out to the control panel system.
To enter into Walk test Mode:
1.
2.
4.5

Event Memory Recall mode

This function allows you to playback the last 254 system events that occurred.
Event Memory recall mode reports all alarms and each arming or disarming of the system and
helps in troubleshooting system faults.
The events are shown using the keypad indicators. Defined events are shown using keypad
indicators.
To enter Event memory Recall mode:
Enter your code + [5] and press #. Two beeps sound. The events are played back by the
keypad indicators in reverse chronological orer.
Bosch Sicherheitssysteme GmbH
5 RF Power Fault
Warning Device Failure List
1 Warning Device 1 Disconnected
2 Warning Device 1 Short
3 Warning Device 2 Disconnected
4 Warning Device 2 Short
Telephone Line Fail
Date and Time Fail
Communications failure
1 Communication Failure 1
2 Communication Failure 2
3 Communication Failure 3
4 Communication Failure 4
Tamper
1 On board Tamper
2 Keypad 1 Tamper
3 Keypad 2 Tamper
4 Keypad Lock out
5 Sensor Tamper (Zone 1-8)
6 Tamper Zone (Zone 1-8)
External Fault
Enter your Code + [4] and press [#].
Two beeps sound and the STAY and AWAY indicators flash. The keypad beeps once per
second when walk test mode is active.
Unseal and seal the zones to be tested.
The keypad sounds one second beep and the siren sounds one beep each time when a
Zone status is changed.
Installation Manual
User Guide | en 25
F.01U.241.127 | V4 | 2011.12