System Functions; Duress Alarm - Bosch AMAX panel 2000 Installation Manual

AMAX panel 2000 / AMAX panel 2000 EN
6

System Functions

User
Code
Default Pads on PCB
6.1

Duress alarm

This function allows code holders to perform a keypad Duress Alarm.
A Keypad Duress Alarm is used as a silent holdup alarm when 0 is added to the end of a valid
Code used to disarm the system.
Bosch Sicherheitssysteme GmbH
Install Function
er
Code
• • 0
• • 1
• • 2
• • 3
• • 4
• • 5
• • 6
• • 7
• • 8
• • 9
• • 96
• 97
• 98
• • 99
• 955
• 956
• 956
• 957
• 958
• 959
• 960
• 961
• 962
• 963
• 999
Installation Manual
Description
# Duress alarm (Refer to 6.1 )
# Siren test (Refer to 6.2 )
# Fault and Tamper analysis (Refer to 6.3 )
# View date and time (Refer to 6.4 )
# Walk test (Refer to 6.5 )
# Event memory recall (Refer to 6.6 )
# Reset panel/clear siren (Refer to 6.7 )
# Initiate a modem call (Refer to 6.8 )
# Send Test report (Refer to 6.9 )
# Bypass (inhibit) (Refer to 6.10 )
# Show Zone type (Refer to 6.11 )
# Bypass all faults (Refer to 6.12 )
# Enable=# / Disable=* installer code user's access (Refer to
* 6.13 )
# Change individual code (Refer to 6.14 )
# Change/View date and time (Refer to 6.15 )
# Add/delete a level 2 user (Refer to 6.16 )
# Add/delete Remote Radio User Codes (Refer to 6.17 )
# Change domestic phone numbers (Refer to 6.18 )
# Enter Programming Mode (Refer to 6.19 )
# Exits from installer's programming mode without saving
the programmed data. (Refer to 6.20 )
# Exits from installer's programming mode with saving the
programmed data. (Refer to 6.21 )
# Resets the control panel to factory defaults. (Refer to
6.22 )
# Copies the control panel memory to the programming key.
(Refer to 6.23 )
# Copies the programming key data to the control panel
memory. (Refer to 6.24 )
# Displays the software version number or control panel
type. (Refer to 6.25 )
Default the control panel with the hardware (Refer to
6.26 )
System Functions | en 39
F.01U.241.127 | V4 | 2011.12