Communication Failure 4; Tamper Condition; On Board Tamper; Keypad 1 Tamper - Bosch AMAX panel 2000 Installation Manual

36 en | Fault and Tamper Description
The fault is reset when the first kissoff tone is received and fault is reset.
Supervise:
1.
2.
3.
5.6.4

Communication Failure 4

Condition:
Panel can not send the report to the Destination 4 after 4 attempts.
Restore:
The fault is reset when the first kissoff tone is received and fault is reset.
Supervise:
1.
2.
3.
5.7

Tamper Condition

The zone indicator 7 lights to indicate Tamper conditions. Enter [7] to step to Tamper
conditions list for more information.
5.7.1

On Board Tamper

Onboard Tamper Condition is registered when the Onboard Tamper input (P8) is open.
Condition:
Onboard Panel Tamper input P8 is open.
Restore:
The Tamper condition is reset when the Input is shorted and Tamper condition is reset.
Supervise:
1.
2.
3.
5.7.2

Keypad 1 Tamper

Condition:
Keypad 1 is opened and the Tamper contact is triggered.
Restore:
The Tamper condition is reset when the Keypad is closed and Tamper condition is reset.
Supervise:
1.
2.
3.
5.7.3

Keypad 2 Tamper

Condition:
Keypad 2 is opened and the Tamper contact is triggered.
Restore:
F.01U.241.127 | V4 | 2011.12
Report the fault to configured destination on location 140 when the fault is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Report the fault to configured destination on location 140 when the fault is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Report the Tamper condition to configured destination on Location 140 when the
Tamper Condition is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the Tamper Condition is reset, send the restored report to the configured
destinations.
Report the Tamper condition to configured destination on Location 140 when the
Tamper Condition is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the Tamper Condition is reset, send the restored report to the configured
destinations. The FAULT indicator is turned off when there is no other system fault.
Installation Manual
AMAX panel 2000 / AMAX panel 2000 EN
Bosch Sicherheitssysteme GmbH