Creating The Configuration File - Siemens SINUMERIK 840D sl Commissioning Manual

8 Tool Management
8.8 Configuring the operator interface
8.8.3

Creating the configuration file

Syntax
8-112
You must save all changes made in the lists with respect to the default setting in
configuration file TO_TURN.INI.
Please note the following:
S
After the column "DP number" you can define further columns and also hide
existing columns.
S
The number of columns displayed is limited by the width of the window be-
cause each column has a fixed width. Horizontal scrolling is not possible.
S
Per column define cutting edge parameters only, tool parameters only, or
magazine parameters only.
S
Define the cutting edge parameters in consecutive columns.
The sample file TO_TURN.INI, which can be adapted, is located in ShopTurn
on NCU (HMI Embedded) under
CYCLE_STORAGE\SEQUENCER_CYCLES\TEMPLATES_ENG.
The adapted file is then found on the CF card (NCU 7x0) under
– oem\sinumerik\hmi\cfg\
– user\sinumerik\hmi\cfg\.
For ShopTurn on PCU 50.3, this example is located on the supplied CD under
Tools\TEMPLATES_ENG.
The file is copied to the directory OEM or USER.
Entries in the configuration file are subject to the following syntax rules; (see
also example at end of this section):
First specify in which tool management list you would like to make changes.
[DISPLAY_IDENTIFIER]
DISPLAY_IDENTIFIER: Tool management list
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
© Siemens AG 2006 All Rights Reserved
11/2006