Nck Startup - Siemens SINUMERIK 840D sl Commissioning Manual

11/2006
4.2.5

NCK startup

SINUMERIK
840D sl
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
NCK start–up comprises the following points:
S
Set up axes and spindle(s)
S
Load ShopTurn machine data, definitions, and cycles
S
Set up tool management
You only need to set up the axes and spindles if you have not yet done so on
the machine. When setting up the axes and spindles please observe the gen-
eral conditions; (see Section 2 "General conditions").
Similarly, you only need to set up tool management in the NCK if this does not
yet exist.
Note:
Example files are located in the directories
CYCLES\SC\PROG\TEMPLATES_DEU and CYCLES\SC\PROG\
TEMPLATES_ENG.
If axes and spindles have not yet been
set up:
Adapt the standard MD to the axes and
spindles of the machine.
Check the MDs in the mask
"Machine data" and if necessary modify
the axis setting data; (see section 7.1
"NC machine data for ShopTurn").
NCK Reset
Fig. 4-3 NC SINUMERIK 840D sl installation and startup
4 Commissioning
4.2 Initial start–up
1
4-23