Designating A Load Magazine In The Tool List Sorted According To Magazines - Siemens SINUMERIK 840D sl Commissioning Manual

8 Tool Management
8.8 Configuring the operator interface
8.8.6 Designating a load magazine in the tool list sorted according to
magazines
Example
8.8.7 Define texts
8-120
If the tool list is sorted according to magazines, all of the magazine locations are
displayed in an increasing sequence according to magazine location and maga-
zine number. Using the configuration file to_turn.ini, a magazine can be high-
lighted as a load magazine by sorting this magazine so that it is directly at the
beginning of the tool list (sorted according to magazines).
ID for the load magazine:
OEM_LOAD_MAGAZINE
[OEM_LOAD_MAGAZINE]
MAGAZINE = 3
In this example, magazine 3 is configured as load magazine,. The magazine
locations of magazine 3 are displayed directly at the beginning of the tool list
that is sorted according to magazine locations.
Texts (softkey name and list header for additional lists, column headers, and
cursor texts for user–defined parameters) are assigned to specific text numbers
in a text file.
These are subject to the following syntax:
Text number 0 0 "Text"
The two parameters 2 and 3 separated by blanks are control characters for text
output and must always be set to 0.
The column header in the parameter name can consist of three lines, each line
with its own text number; (see Table 8-6).
Table 8-6 Text assignment
Text type
3rd horizontal softkey
List header
Column header parameter TPC1
Cursor text parameter TPC1
Column header parameter TPC2
Cursor text parameter TPC2
Column header parameter TPC3
Cursor text parameter TPC3
Column header parameter TPC4
Cursor text parameter TPC4
Column header parameter TPC5
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Text number
89923
89924
89925, 89926, 89927
89931
89928, 89929, 89930
89932
89953, 89954, 89955
89965
89937, 89938, 89939
89949
89940, 89941, 89942
© Siemens AG 2006 All Rights Reserved
11/2006