Machine Manufacturer Cycle - Siemens SINUMERIK 840D sl Commissioning Manual

11/2006
11.2

Machine manufacturer cycle

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
The machine manufacturer cycle ST_CUST.SPF is called by the ShopTurn
cycles.
Adapt the cycle if you want to perform one of the following actions:
S
Switch between spindle and C axis mode of the main spindle or counter–
spindle.
Marks _M1, _M2, _M21, _M22
(see also Section 9.6 "Counter–spindle")
S
Clamp or release the rotary axes (main spindle/counter–spindle).
Marks _M3, _M4, _M23, _M24
(see also MD 9843 $MM_ST_ENABLE_SPINDLE_CLAMPING)
S
Open, close, flush chuck (main spindle /counter–spindle).
Marks _M5 to _M8, _M25 to _M29
(see also Section 9.6 "Counter–spindle")
S
Engage/disengage rotating tool (make/break connection to drive).
Marks _M41, _M42
S
Configure special functions for switchover between machining planes.
(You do not have to make any settings for cylinder surface transformation or
face end machining with the C axis.)
Marks _M61 to _M68
S
Position, extend, or retract receptacle for cutting off.
Marks _M100, _M101, _M102
(see also MD 9841 $MM_ST_ENABLE_PART_OFF_RECEPT)
S
Configure special functions for tool changing. (These special functions are
called after the T command is output.)
Marks _M110, _M111, _M112
S
Change default for coupling between main spindle and counter–spindle.
Mark _M120
(see also Section 9.6 "Counter–spindle")
S
Set special properties for program start or program end.
Marks _M131, _M135, _M136
The cycle is located in directory CYCLES\SC\PROG\TEMPLATES.
11 Miscellaneous
11.2 Machine manufacturer cycle
11-169