Table of Contents
Advertisement
Figure 21-47 TransNET 900 Radio Modem Mounted on Metal Bracket - Front and Rear View
2.
Mount the bracket on the RTU chassis above the I/O modules, using the four built-in
screws. (See Figure 21-48 and Figure 21-49 below.)
3.
Connect one end of the power cable (FKN8508A) to the TransNET's PWR (9-30VDC)
connector and tighten the attached screws. Connect the other end of the cable to the
AUX1A connector on the RTU's power supply module.
4.
Connect one end of the data cable (FKN8514A) to the TransNET's DATA connector
using the attached screws. Connect the other end of the communication cable to the
ACE3600 CPU module port configured for the radio.
5.
Connect the small end of the antenna cable (FKN8511A) to the TransNET's ANT
(Antenna) connector.
Unscrew the nut and locking washer from the other end of the antenna cable.
If the RTU is inside an enclosure, thread the end of the cable through the opening on the
bottom of the enclosure and screw on the nut and locking washer from outside the
enclosure.
6.
Connect the antenna cable to an external antenna.
21-57
Radio Types and Installation Kits
Advertisement
Table of Contents
